I immediately noticed the floating extrusion. but when you said this i realized they where right next to each other. if thats a bad sensor the manual leveling might work but i wonder if theres something(probably a bit of filament waste) under the sheet causing it to ripple or the build plate isnt very flat.
a high spot during probing could cause havoc on the interpolation and i could see it causing something like this. manual leveling would kinda help that but that spot would still be a disaster.
I immediately noticed the floating extrusion. but when you said this i realized they where right next to each other. if thats a bad sensor the manual leveling might work but i wonder if theres something(probably a bit of filament waste) under the sheet causing it to ripple or the build plate isnt very flat.
a high spot during probing could cause havoc on the interpolation and i could see it causing something like this. manual leveling would kinda help that but that spot would still be a disaster.
Yeah it’s a weird thing that I would assume cones from bad slicing, a bad bed or bad mesh leveling. But this can have different reasons too.
Further there are holes in the print, which are a possible problem with extrusion width
Edit: it could also be that it was a bed level change mid print notice how some of it is printed over.