Sorry I had an emergency and was away. My bed level wasnt good I think. I did some leveling and all again now the prints are fine. Yet still minor (negligible) issues with the print. My nozzle may be not that good now. Its old. But since the prints are fine now so Im using It.
Yeah it’s a weird thing that I would assume cones from bad slicing, a bad bed or bad mesh leveling. But this can have different reasons too.
Further there are holes in the print, which are a possible problem with extrusion width
Edit: it could also be that it was a bed level change mid print notice how some of it is printed over.
Sorry I had an emergency and was away. My bed level wasnt good I think. I did some leveling and all again now the prints are fine. Yet still minor (negligible) issues with the print. My nozzle may be not that good now. Its old. But since the prints are fine now so Im using It.
Yeah not a problem. If I don’t get an answer than I just assume it’s solved