Ender 3 can be a bit finicky. Make sure to check all corners at least twice after leveling. When you level one side, another can be out of level again.
You can also try a different bed material. A glass plate is more flat than the flex one.
If your printer is fully stock, replacing the bed springs either with silicone spacers or stiffer springs can be a good value upgrade. Keeps the bed from unleveling itself while printing, and IMO it also makes the initial adjustment a tiny bit easier. A bed probe is an immense quality of life improvement though, if you can afford to spend a little more money, since it both compensates for less-than-perfect bed leveling and also for any unevenness in the bed surface.
On the subject of upgrades, stay away from the “all-metal extruder” which used to be popular on Amazon etc. The stock Ender 3/v2 extruder is poorly designed and breaks easily. The metal version of it doesn’t break, but it’s still has the same bad design. If you’re going to invest money in a new extruder there are better options.
Seems like the top right corner is getting really close to the nozzle. Could be levelling, yeah.
I’m not sure how the ender works, but on my mk3s, I’ve had gunk under the springboard that did something similar.
Thanks. I will check it. I thought I did the leveling correctly prior to printing.
Ender 3 can be a bit finicky. Make sure to check all corners at least twice after leveling. When you level one side, another can be out of level again.
You can also try a different bed material. A glass plate is more flat than the flex one.
If your printer is fully stock, replacing the bed springs either with silicone spacers or stiffer springs can be a good value upgrade. Keeps the bed from unleveling itself while printing, and IMO it also makes the initial adjustment a tiny bit easier. A bed probe is an immense quality of life improvement though, if you can afford to spend a little more money, since it both compensates for less-than-perfect bed leveling and also for any unevenness in the bed surface.
On the subject of upgrades, stay away from the “all-metal extruder” which used to be popular on Amazon etc. The stock Ender 3/v2 extruder is poorly designed and breaks easily. The metal version of it doesn’t break, but it’s still has the same bad design. If you’re going to invest money in a new extruder there are better options.